Further Built-In Features; Automatically Launched Actions - The Event Manager; Receiver Cloning - Configuration Backup And Restore; Remote Firmware Upgrade Of Connected Lightware Devices - Lightware HDMI-TPS-RX110AY Series User Manual


  
4.DeviceConcept
4.7. Further Built-in Features
4.7.1. Automatically Launched Actions – The Event Manager
The Event Manager feature means that the device can sense changes on its ports and is able to react
accordingtothepre-definedsettings.LightwareDeviceControllercontainsauser-friendlysoftwaretooland
allowstocreateEventsbydefiningaConditionandanAction.
See more information about the settings in the
4.7.2. Receiver Cloning – Configuration Backup and Restore
Thereceiver(configuration)cloningofHDMI-TPS-RX110AYisasimplemethodthateliminatestheneedto
repeatedlyconfigurecertaindevicestohaveidentical(non-factory)settings.Ifthedevicesareinstalledin
thesametypeofsystemmultipletimesthenitisenoughtosetuponlyonedevicetofittheuser'sneedsand
then copy those settings to the others, thus saving time and resources.
See more information about the settings in the
4.7.3. Remote Firmware Upgrade of Connected Lightware Devices
The firmware of the Lightware TPS devices can be upgraded individually by Lightware Device Updater
(LDU)software.HDMI-TPS-RX110AYcontainsafeaturewhichallowshavingafasterandmorecomfortable
firmware upgrade process. When the firmware of the connected extenders has to be upgraded the TPS
connectionisnecessarytowardstheextenders–nothingelse.TheLDUwillfindtheconnecteddevicesand
can upgrade them.
The upgrade process is almost the same as in the case of the usual upgrade process. See the details of the
process in the RemoteFirmwareUpgradeofConnectedLightwareDevices
Event Manager example
Event Manager section.
ConfigurationCloning(BackupTab) section.
section.
Appliedfirmwarepackage:v1.4.0 | LDCsoftware:v2.4.0b3
HDMI-TPS-RX110AY series – User's Manual
4.8. Software Control Modes
User has more possibilities to control the device besides the front panel buttons. The following list contains
thesoftwarecontrolmodes:
▪
Lightware Device Controller (LDC):youcanconnecttothedeviceviaourcontrolsoftwarewithusingUSB,RS-
232orEthernetinterfacesandcontrolorconfigurethedeviceasyouwish.ForthedetailsseetheSoftware
Control-LightwareDeviceController
▪ LW2 protocol commands: you can configure the device by using the reduced command set of LW2
protocol. For more details see the
▪ LW3 protocol commands: you can configure the device by using the full-range command set of LW3
protocol. For more details see the
chapter.
LW2Programmers'Reference chapter.
LW3Programmers'Reference chapter.
27