Centralized Firmware Upgrade - Detailed Instructions - Lightware UBEX Series User Manual

 
     
10. Firmware Upgrade 10. Firmware Upgrade
10.5.3. Centralized Firmware Upgrade - Detailed Instructions
Preparing the Upgrade
Step 1. Open the Lightware Device Controller (LDC) software.
Step 2. Establish connection with the MMU.
Step 3. Navigate to the Settings / Upgrade Firmware menu.
The Layout of the Upgrade Firmware Menu
1
9
8
7 6
1 Endpoint firmware The firmware package version of the endpoint is displayed here which is built
package version in the MMU. This version will be applied on the endpoint devices after the
centralized firmware upgrade is completed.
Show detailed The explanation of the two available options is the following:
2
status switcher
▪ Enabled: the last text message of the firmware upgrade status is
displayed in the Firmware Status column.
▪ Disabled: the recent status of the firmware upgrade is displayed in
percent.
3 Filters The list of the endpoint devices can be filtered, see the details in the
section (on the right side).
Factory defaults Clicking on the button results applying factory default settings on the selected
4
button endpoint devices. See the details about the applied settings in the
Default Settings
5 Reset button Clicking on the button results restarting the selected endpoint devices.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | Applied MMU firmware package: v1.2.1 | LDC software: v1.34.0b2
2
5 4
section.
UBEX series – Matrix Application Mode – User's Manual UBEX series – Matrix Application Mode – User's Manual
Identify me button
6
7 Update firmware
button
Endpoint device
8
selectors
9 Header
3
Filters
Applying filters help to find the required endpoint devices for upgrading
in case of a larger UBEX matrix. The function contains the following filter
categories:
▪
Device:
– UBEX-PRO20-HDMI-F100
– UBEX-PRO20-HDMI-F110
– UBEX-PRO20-HDMI-F120
– UBEX-PRO20-HDMI-R100
▪
Operation Mode:
– Transmitters
– Receivers
– Transceivers
▪ Connection Status:
– Online
– Offline
▪ Firmware Status:
– Up-to-date
– Out of date
– Update in progress
Filters
Factory
Clicking on the button causes the four front panel LEDs blink in green for 10
seconds. The feature helps to identify the device itself in the rack shelf.
Clicking on the button results starting the firmware upgrade procedure on the
selected endpoint devices with the package version displayed in the Endpoint
Package Version.
Clicking on the squares the endpoint devices will be selected for firmware
update, identify me function, reseting or factory defaults setting. Clicking on
square next to the header results selecting all devices in the list.
The header of the endpoint list. Clicking on the

the category of the column (e.g. ID, operation mode, label, etc).
164 164
icon sorts the list based on