Indirect Start Via Wago-I/O-Check From The Operating System; Direct Start From The Operating System; Indirect Start Via Wago-I/O-Check From The Configuration Program (Device Level Tci Conformance Class 2); Indirect Start Via Wago-I/O-Check From The Configuration Program (Module Level Tci Conformance Class 2) - WAGO 753-668/000-004 Manual

100 Commissioning
8.3.4.1

Indirect Start via WAGO-I/O-CHECK from the Operating System

In the Windows Start menu, select the entry Programs  WAGO Software 
WAGO-I/O-CHECK  WAGO-I/O-CHECK 3.
Select an F I/O module for parameterization from the displayed fieldbus node
configuration. Execute the Settings command in the WAGO-I/O-CHECK in the
context menu of the F I/O module (node view or navigation). WAGO-I/O-CHECK
then starts WAGO Safety Editor 75x with the current language and
communication settings. The WAGO Safety Editor is started in ONLINE mode.
Communication occurs over the serial connection for a PROFIBUS fieldbus
coupler and over the serial connection or ETHERNET for a PROFINET fieldbus
coupler depending on the current communication setting in WAGO-I/O-CHECK.
8.3.4.2

Direct Start from the Operating System

In the Windows Start menu, select the entry Programs  WAGO Software 
WAGO-I/O-CHECK 3  WAGO Safety Editor 75x.
The WAGO Safety Editor is started in OFFLINE mode.
8.3.4.3 Indirect Start via WAGO-I/O-CHECK from the Configuration Program
(Device Level TCI Conformance Class 2)
In the configuration program of the safe PLC, select a device (fieldbus coupler)
and launch "WAGO-I/O-CHECK 3" from the TCI link. The configuration program
passes the current language and communication setting to WAGO-I/O-CHECK.
Select an F I/O module for parameterization from the fieldbus node configuration
displayed in WAGO-I/O-CHECK. WAGO-I/O-CHECK then starts WAGO Safety
Editor 75x with the current language and communication settings. The Safety
Editor is started in ONLINE mode.
Communication occurs over the serial connection for a PROFIBUS fieldbus
coupler and over ETHERNET for a PROFINET fieldbus coupler.
If you want to exit the configuration of the F I/O module and to close the Safety
Editor, then WAGO-I/O-CHECK is also closed.
8.3.4.4 Indirect Start via WAGO-I/O-CHECK from the Configuration Program
(Module Level TCI Conformance Class 2)
In the configuration program, select an F I/O module and from the TCI link
"WAGO-I/O-CHECK 3", start the WAGO-I/O-CHECK. The configuration program
passes the current language and communication setting to WAGO-I/O-CHECK.
WAGO-I/O-CHECK then starts WAGO Safety Editor 75x with the current
language and communication settings. The Safety Editor is started in ONLINE
mode.
Communication occurs over the serial connecting cable for a PROFIBUS fieldbus
coupler and via the TCP/IP connection for a PROFINET fieldbus coupler.
Manual
Version 1.0.0, valid from HW/SW Version 01/01
753-668/000-004 4FAI 0/4-20 mA Diff PROFIsafe
WAGO-I/O-SYSTEM 750