Installation Procedures - Omron K6CM Startup Manual

(4) Check the check box of "Microsoft .NET Framework 3.5.1" and click "OK".

2 Installation Procedures

This section shows the procedure for installing a new Motor condition monitoring Tool.
使用上の注意 使用上の注意
Precautions for Correct Use
"User account control" may be displayed depending on PC settings during installation procedure. In that case, click
"yes" if there is no problem.
(1) Insert the attached CD in the PC and select "setup.exe" from the autoplay screen.
If automatic playback was not done, double-click the "setup.exe" file under the CD drive.
The following [Select language setting] Dialog Box will be displayed.
If the following message is displayed, the old version of CX-Compolet/SYSMAC Gateway has already
been installed on the PC. In order to use Motor condition monitoring Tool, upgrade of CX-Compolet/
SYSMAC Gateway is necessary.
Please read "3.5. Upgrade installation" of "CX-Compolet_SGW_InstallationGuide_E.pdf" in the Manual
folder on the CD and uninstall the CX-Compolet/SYSMAC Gateway after backing up the data. Then re-
perform step (1).
CAUTION
9