Sample Program Execution Procedures - Omron K6CM User Manual

8 Monitoring and Setting Using the EtherNet/IP Devices
iMotorTempAlarm_Critical
iDiffTempAlarm_Warning
iDiffTempAlarm_Critical
SetISM
iApplicableCircuit
iUsingInverter
iInverterSpecialMeas
rInsRegistAlarm_Warning
rInsRegistAlarm_Critical
SetCIM
iCurrentRange
rCurrentAlarm_Warning
rCurrentAlarm_Critical
iDegradationAlarm_Warning
iDegradationAlarm_Critical
dummy
sDummy
tTime
?
8-4-3

Sample Program Execution Procedures

The following is the procedure to execute the sample program.
1
IP Address Settings of Devices
The setting method depends on the device. Set as follows:
K6CM:
PLC:
PC:
2
Network configuration
Configure each device refering to the network configuration example described in 8-4-1 Sample
Program Overwiew on page 8-29.
3
Importing the Sysmac Studio Project File
To import the sample program project file, perform one of the following:
(1) Double-click the project file (.smc2, .csm2, etc.).
The Sysmac Studio starts and it is imported automatically.
(2) Select [Import] in the start page of the Sysmac Studio and specify the project file.
After importing the file, perform the device settings according to the PLC model to be used
as necessary.
Device settings can be performed from [Controller] | [Change Device] in the Sysmac Studio.
4
Setting of the PLC clock
Go online to the PLC, and then set the PLC clock with [Controller Clock] of the Sysmac Studio.
(Refer to the Sysmac Studio Version1 Operation Manual (Cat. No.W504) section 8-2)
8 - 36
Name
UINT
UINT
UINT
STRUCT
UINT
UINT
UINT
REAL
REAL
STRUCT
UINT
REAL
REAL
UINT
UINT
STRUCT
STRING[256]
TIME
Set it with the start navigation of the software tool (Motor condition monitoring tool).
Refer to 4-3-2 IP Address Setting of the K6CM Devices on page 4-27
- If you have not imported the project file in the Sysmac Studio, set it with [Connect to
Device] on the start page of the Sysmac Studio.
(Refer to the Sysmac Studio Version1 Operation Manual (Cat. No.W504) section 6-2-8)
- If you have imported the project file in the Sysmac Studio, set it with [Communications
Setup] of the Sysmac Studio.
(Refer to the Sysmac Studio Version1 Operation Manual (Cat. No.W504) section 6-2-2)
Set it from the Control Panel. Refer to4-2-2 Uninstallation Procedures on page 4-24.
Data type
Motor temperature alarm (Critical)
Temperature Gap alarm (Warning)
Temperature Gap alarm (Critical)
Setting object (ISM)
Applicable circuit
Using inverter
Inverter special measurement
Insulation resistance alarm (Warning)
Insulation resistance alarm (Critical)
Setting object (CIM)
Current range
Current alarm (Warning)
Current alarm (Critical)
Degradation level alarm (Warning)
Degradation level alarm (Critical)
Dummy variable
Dummy variable
Dummy variable
K6CM Motor Condition Monitoring Device User's Manual (N219)
Comment