3.2
Basic functions
Applicable phase wire
PMU1A
PMU2A
(Electric
(Power
power)
two-system)
•
Set the phase wire to be measured.
•
Setting range: Single-phase 2-wire, single-phase 3-wire, 3-phase 3-wire, and 3-phase
4-wire (initial value: 3-phase 3-wire)
*1. For PMU2A (power two-system), 3-phase 4-wire cannot be set.
*2. CTD8E (CT expansion) can perform the two-system measurement only when it is
connected to PMU2A (power two-system).
Synchronization selection for measuring block
PMU1A
PMU2A
(Electric
(Power
power)
two-system)
×
×
•
Set the voltage system synchronized with a measuring block.
•
Setting range: System 1, system 2 (initial value: system 1)
The measuring blocks are divided into measuring block 1 and measuring block 2, which are
assigned to system 1 and system 2, respectively, to perform power measurements. For
PMU1A and PMU2A, since their measuring blocks and voltage systems are fixed, the setting
of synchronization selection for measuring block is not required.
Dedicated CT type
PMU1A
PMU2A
(Electric
(Power
power)
two-system)
•
Set the dedicated CTs to be used.
•
The dedicated CTs are as follows.
Split type
CT Model
Model KM20-CTF-5A
Model
KM20-CTF-50A
Model
KM20-CTF-100A
Model
KM20-CTF-200A
Model
KM20-CTF-400A
Model
KM20-CTF-600A
•
Setting range: 5 A, 50 A, 100 A, 200 A, 400 A, 600 A (initial value: 100 A)
* CTD8E (CT expansion) can perform the two-system measurement only when it is
connected to PMU2A (power two-system).
* PMU2A (power two-system) can set dedicated a CT type for each system. CTD8E (CT
expansion) can set a type for each measuring block.
EMU8A
CTD8E
(Pulse/temperature)
(CT
expansion)
×
EMU8A
CTD8E
(Pulse/temperature)
(CT
expansion)
×
EMU8A
CTD8E
(Pulse/temperature)
(CT
expansion)
×
Panel fixed (through) type
Standard
5A
Model KM20-CTB-5A/50A
50A
100A
200A
400A
600A
: With settings of two-system O: With setting X: Without setting
O: With setting X: Without setting
: With settings of two-system O: With setting X: Without setting
CT Model
3.6
Other functions
Standard
5A/50A
3-3