Siemens Sinumerik 840D Operating Turning page 710

Section 2
Notizen
B905
B905
Program example
Fill in the values. Every element in tangential previous element.
Always press the softkey „tangent previous ele-
Tipp
ment" first. If not you can`t see any connection
between the element.
The endpoint of the last element is the startpoint of our contour. The con-
tour is closed. By using the cycle milling a contour spigot it is necessary to
close the contour. Otherwise it doesn`t work.
page 10 840D/828D SINUMERIK Operate