Siemens Sinumerik 840D Operating Turning page 435

Simple programming example
Description:
A simple contour turning G code program, using a contour and stock re-
moval cycle is to be programmed with the programGUIDE in ShopTurn.
Aim:
A new G code program is to be created and opened.
The G code lines and the stock removal cycle must be programmed and
the program is to be simulated.
For this, the data below are to be used:
Tool data: ROUGHING_TOOL_A80
Technology data: F 0,4 mm/U, V 200 m/min
Starting-up technol- As a start position for the machining, the following
ogy: position is to be programmed:
X
Z
This position is approached in rapid traverse.
2.1 Creating a new ShopTurn programGUIDE program
A new G code program can be created within the operating modes „JOG",
„MDA" and „AUTO", as follows:
1. Press the "Program Manager"-key on the keyboard.
The program manager will be opened directly.
- OR -
1. Press the "MENU SELECT"-key on the operator
panel.
Press the yellow HSK 1.4 "Program Manager".
The program manager opens.
2. Select a drive where you want to create the program
("NC", "Local drive", "USB"), by pressing the corre-
sponding horizontal softkey.
3. Press the VSK 2 "New".
The vertical softkey bar with functions for creating
new programs opens.
4. Press the VSK 4 „programGUIDE G code" to open
the input mask for creating a new G code program.
Select "Main program MPF".
5. Enter a name for the program in the "Name" field,
e.g DIN_CONTOUR_1.MPF and accept with press-
ing the VSK 8 "OK".
The editor window for entering G code commands
opens.
840D/828D SINUMERIK Operate
30
0
Section 2
Notes