Siemens Sinumerik 840D Operating Turning page 447

Complex programming example
Insert another contour call "CYCLE62" into the pro-
17.
gram.
Press now the VSK 1 "Contour".
The vertical softkey bar for creating or calling up a
contour opens.
Press the VSK 2 "Contour call" to open the input
mask for the call up of a contour.
18. Enter the following contour name into the parameter
mask:
Confirm your input by pressing the VSK 8 "Accept".
The following line is inserted into the program:
N240 CYCLE62("SPIGOT_FINISHED",1,,)
Note:
The contour "SPIGOT_FINISHED" you called up
here, will be created in section 52.
19. Insert a residual cutting cycle "CYCLE952" into the
program.
Press the VSK 3 "Cut resid. stock".
The "Cut residual material" parameter window
opens.
20. Fill out the parameter mask as follows:
840D/828D SINUMERIK Operate
Section 3
Notes