Siemens Sinumerik 840D Operating Turning page 501

Complex measurement example
Press the VSK 1 "Blank" to open the input mask for
the 'Blank'-parameters..
3. Enter the following parameters for the 'Blank':
Acknowledge the input with the VSK 8 "Accept". The
following line will be inserted.
N110 WORKPIECE(, ,"","PIPE",448,0,-100,-
80,100,50)
4. Now add a measuring probe for the measuring mo-
tion into the program.
Press the VSK 1.1 "Select tool".
The tool list is opened.
With the blue cursor-keys on the keyboard select the
tool "3D_PROBE_BLUM".
Press the VSK 1.1 "To program".
The program line N120 T="3D_PROBE_BLUM"
is added to the program.
Conversely this line can also be programmed manu-
ally.
5. Programme the following G-Code lines:
N130 M6
N140 G0 X0 Y0 Z5
N150 G0 Z-10
6. Programme the first measuring cycle for the internal
measurement of the pipe.
For this press the key "Extension" on the operator
panel to swap to the horizontal softkey-strip 2.
The horizontal softkey-strip 2 is opened.
Press the HSK 2.6 "Measurem. milling".
The operating range "Measurement milling" with ex-
tended measuring functions is opened.
Press the VSK 4 "Workpiece measure".
The vertical softkey-strip with functions for the meas-
uring of work pieces is opened.
Press the VSK 2 "Hole Shaft".
The vertical softkey-strip with functions for the meas-
uring of holes or shafts is opened.
Si840D/828D SINUMERIK Operate
Section 3
Notes