Siemens Sinumerik 840D Operating Turning page 585

Simple programming example
Confirm your inputs by pressing the VSK 8 "Accept".
The following program block "Program header" will
be inserted into the work plan.
3. Program now a multi-edge machining.
For this, press the HSK 1.5 "Mill.".
Press the VSK 3 "Multi-edge spigot".
Press the VSK 5 "Multi edge".
The parameter mask for the cycle "Multi edge"
opens.
4. Fill out the parameter mask as follows:
To insert a tool into the parameter mask, press the
VSK 1 "Select tool", mark the desired tool
(CUTTER_D8) in the tool list with the orange selec-
tion cursor and press the VSK 1 "To program"
The following program block "Multi-edge" is inserted
into the program.
5. Program the end of the program and simulate the
machining.
Place the orange selection cursor on the program
block "End of program" and extend the program
block by pressing the blue "cursor-to-the-right"-key
on the keyboard.
The settings window for the program end opens,
where you can define to repeat the workpiece.
Accept the default value by pressing the VSK 8
"Accept".
The program end is updated:
840D/828D SINUMERIK Operate
Section 2
Notes