Siemens Sinumerik 840D Operating Turning page 518

Section 3
Creating ShopTurn programs
Notes
3.4 Programming the end of the program
The program block "End of program" is programmed automatically when-
ever you create a new ShopTurn program.
To modify the default settings for the program end, mark the line "End of
program" with the orange selection cursor and press the blue "cursor-to-
the-right" key.
The parameter window for the program end opens, where you can modify
the numbers of workpieces you want to machine.
Enter the numbers of workpieces you want to machine and accept with
pressing the VSK 8 "Accept" or abort with pressing the VSK 7 "Cancel".
You can set the number of workpieces to infinite by pressing the VSK 5
"Infinite".
The values you have inserted are updated automatically
B601
B601
Page 10 840D/828D SINUMERIK Operate