Siemens Sinumerik 840D Operating Turning page 351

Storage medium "NC"
Press the VSK 6 "Paste" to insert the clipped data
6.
to the directory or storage location of your choice.
Accept your selection by pressing the VSK 8 "OK" or
abort with pressing the VSK 7 "Cancel".
The source file or directory will be deleted.
3.8 Deleting directories / NC-programs
1. Move the cursor with the blue cursor keys to the direc-
tory or file which you want to copy. If you want to
copy more then one program or directory, mark them
first (see section 3.5).
Press the VSK 2.7 Delete" in the extended vertical
2.
softkey bar 2. Accept the deletion process with press-
ing the VSK 8 "OK" or abort with pressing the VSK 7
"Cancel".
The selected program or directory will be deleted.
3.9 Opening a preview window
Press the VSK 2.2 "Preview window" in the extended
1.
vertical softkey bar.
The preview sub window opens directly below the pro-
gram manager window.
Use the blue cursor keys to navigate to the program
2.
you want to preview.
The program code of the selected program is now dis-
played in the preview window.
To deselect the function press the VSK 2.2 "Preview
3.
window" again.
The preview window disappears.
Note: You cannot edit program code in the preview window.
Tip 5: Press the "NEXT WINDOW"-key on the keyboard to acivate the pre-
view window. Now you can navigate freely through the program code by us-
ing the blue cursor keys.
Tip 6: The preview window stays active, even if you switch back to the verti-
cal softkey bar 1, in order to copy or cut a program or directory.
840D/828D SINUMERIK Operate
Section 3
Notes