Siemens Sinumerik 840D Operating Turning page 599

Complex programming example
Description:
A more complex ShopTurn program (threaded spigot) with the call up of
different turning cycles (stock removal, groove, undercut, thread longitudi-
nal, cut off) is to be created.
Aim:
The workpiece shown below is to be programmed.
The following tool- and technology data are needed for the programming:
Tool- and ROUGHING_TOOL_A80
technology data: ( F 0.300 mm/rev)
FINISHING_TOOL_35
(F 0.150 mm/rev)
PLUNGECUTTER_3
( F 0.150 mm/rev)
FINISHING_TOOL_35
(F 0.300 mm/rev)
THREADING_TOOL_2
( F 2.0 mm/rev)
PLUNGECUTTER_3
( F 0.100 mm/rev)
Work piece data: Raw part: Ø 100 x 130 mm
840D/828D SINUMERIK Operate
Section 3
Notes