Siemens Sinumerik 840D Operating Turning page 679

Complex programming example
Description:
A further measuring program with an additional measuring motion is to be
programmed under ShopTurn.
Aim:
The program header, two measuring cycles and the end of the program
are to be programmed.
Following this the program will be simulated.
For this the tool data stated below are to be used:
Tool data: Measuring probe (3D_PROBE)
3.2 Programming example: Internal measuring
The following ShopTurn program with two measuring cycles is to be pro-
grammed:
1. Start a new ShopTurn program as described in the
previous Section 2.1 and name the program
"ST_MEASURE_MILLING_2.MPF".
The input window for the program header will open
automatically.
840D/828D SINUMERIK Operate
Section 3
Notes