Various
5.5.3.3 Setting the work offset
1.
In the operating area "Program" press the HSK 1.6
"Various" and the VSK 5 "Transformations".
2.
Press the VSK 1 "Work offset".
3.
Optionally change the graphic view on the blank by
pressing the VSK 2 "Graphic view".
4.
Select the work offset (Basic reference, G54, G55,
G56 or G57).
Press the VSK 8 "Accept" to confirm your selection
or press the VSK 7 "Cancel" to abort.
A new program block "Work offset" is inserted into
the program in the editor window (alike the picture
below).
5.5.4 Offset
Offsets apply only to the current program.
Besides, you can select between a new and an additive offset.
With a new offset, all offsets defined before are deselected.
An additive offset works additional to the current selected offset.
For every axis an offset can be programmed.
5.5.4.1 Selecting the function "Offset"
By pressing the VSK 2 "Offset" the following screen
for setting the offset opens.
840D/828D SINUMERIK Operate
Section 5
Notes