Siemens Sinumerik 840D Operating Turning page 311
Hide thumbs
Also See for Sinumerik 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating manual (610 pages)
Advertisement
Work offset
3.
Press the VSK "Active", "Base" or "G54...G57".
The corresponding window appears.
4.
Place the cursor on the desired work offset to view
its details.
5.
Press the VSK 7 "Details".
A window opens, depending on the selected work
offset, e.g. "Work offset - details: G54...G57".
6.
Enter your values into the table.
- OR -
6.
Press the VSK 1 "WO +" or the VSK 2 "WO -"
to select the next or previous offset, respectively,
within the selected area ("Active", "Base", "G54 to
G57") without having first to switch to the overview
window. If you have reached the end of the range
(e.g. G57), you switch automatically to the beginning
of the range (e.g. G54).
- OR -
6.
Press the VSK 7 "Clear offset" to reset all entered
values.
Note:
The changes become effective immediately in the part program or after
pressing the "RESET"-key.
7.8 Measuring the workpiece zero
1.
Press the "MENU SELECT"-key on the operator
panel, then the HSK 2 "Parameter" to open the oper-
ating area "Parameter". Alternatively press the
"OFFSET"-key on the keyboard.
2.
Press the HSK 5 "Work offset"
3.
Press the VSK 4 "G54...57".
4.
Select the work offset in which the zero point ist to
be saved by placing the cursor in an axis field right
beside the corresponding work offset G54-57.
5.
Press the VSK 1 "Work Measure".
The main screen oft the operating area "Machine" in
the operating mode "JOG" opens.
6.
Press the HSK 3 "Meas. Workp."
The "Set edge" window opens (if not, select it).
Use the softkeys "X", "Y, "Z" to select in which axis
direction you want to approach the workpiece first.
7
Select the measuring direction (+ or -) you want to
approach the workpiece in.
The measuring direction cannot be selected for Z0.
8.
the workpiece edge you are approaching. Traverse
the tool up to the workpiece edge and press the VSK
7 "Set WO" to measure the workpiece zero.
For more details see module B570 - "Operating mode JOG", section 5
"Measuring the workpiece zero".
840D/828D SINUMERIK Operate
In "X0", "Y0", or "Z0", specify the setpoint position of
Section 7
Notes
Advertisement
