Siemens Sinumerik 840D Operating Turning page 469

Complex programming example
Insert now a tool (ROUGHING_TOOL_A80) into the
4.
program.
Press the VSK 1.1 "Select tool".
The tool list window opens.
Mark the desired tool (ROUGHING_TOOL_A80) in
the tool list window with the orange selection cursor.
Press the VSK 1.1 "To program".
The following program line is inserted into the pro-
gram:
N130 T="ROUGHING_TOOL_A80"
Optional you can program the line by hand.
5. Program the following G code commands:
N140 M6
N150 G96 S260 M4
6. Program the first stock removal cycle.
Press the HSK 1.3 "Turning".
Press the VSK 1 "Stock removal"
The work area for the technology "Stock removal"
opens.
Press the VSK 3 "Stock removal 1", to open the pa-
rameter mask for the "Stock removal 1" cycle.
7. Fill out the parameter mask like displayed below:
Confirm your inputs by pressing the VSK 8 "Accept".
The following program line is inserted into the pro-
gram:
N160 CYCLE951(100,2,-5,0,-5,0,1,2,0.2,0.2,
12,0,0,0,1,0.3,0,2,1110000)
840D/828D SINUMERIK Operate
Section 3
Notes