Siemens Sinumerik 840D Operating Turning page 512

Section 2
Notes
B601
B601
Basics
As a programming graphic in the graphic view (workpiece or machin-
ing step as an outline graphic in side view or top view).
The marked program block in the work plan is highlighted with a differ-
ent colour.
As a parameter mask with a help graphic in 3-D, or a simulation of the
machinining step in side view or face view.
If available, the view changes continuously from the help picture to the
animation.
The animated help graphics are displayed always in the correct position to
the adjusted coordinate system. The parameters are dynamically over-
layed into the graphic and are highlighted in a different colour.
Page 4 840D/828D SINUMERIK Operate