Siemens Sinumerik 840D Operating Turning page 467

Complex programming example
Description:
A more complex G code program (threaded spigot), with the call up of dif-
ferent turning cycles (stock removal, groove, undercut, thread longitudinal,
cutoff) is to be created with the programGUIDE in ShopTurn.
Aim:
The workpiece shown below is to be programmed and simulated after-
wards.
The following tool- and technology data are needed for the programming:
ROUGHING_TOOL_A80 ( F 0.300 mm/rev)
Tool- and
technology data
FINISHING_TOOL_35 (F 0.150 mm/rev)
PLUNGECUTTER_3 ( F 0.150 mm/rev)
FINISHING_TOOL_35 (F 0.300 mm/rev)
THREADING_TOOL_2 ( F 2.000 mm/rev)
PLUNGECUTTER_3 ( F 0.100 mm/rev)
840D/828D SINUMERIK Operate
Section 3
Notes