Siemens Sinumerik 840D Operating Turning page 547

Hide thumbs Also See for Sinumerik 840D:

5.5.7 Mirroring

Mirroring applies only to the current program.

Besides, you can select between a new and an additive mirroring.

With a new mirroring, all mirrorings defined so far are deselected.

An additive mirroring works additional to the current selected mirroring.

Furthermore it is possible to mirror all axes.

Activate the axis to be mirrored in each case.

Note that with mirroring, the travel direction of the cutting tool (down-cut/

up-cut) is also mirrored.

5.5.7.1 Selecting the function "Mirroring"

By pressing the VSK 5 "Mirroring" the following input

mask for mirroring the axes opens.

5.5.7.2 Parameters for "Mirroring"

Adds a new mirroring

840D/828D SINUMERIK Operate

Help picture/animation

Sinumerik 828d