Siemens Sinumerik 840D Operating Turning page 339

Hide thumbs Also See for Sinumerik 840D:

1 Brief description

Aim of the module:

In this module you learn to handle programs and files in the program manager of the Sumerik

Description of the module:

All NC-Programs, which are created with the Sinumerik Operate, are stored in the NC-work memory.

These programs can be accessed via the program manager for:

The SINUMERIK Operate provides the following means of data transmission of NC-programs to

other storage media depending on the system components:

Its own hard disk (only 840D sl with PCU 50.x)

V.24-interface (with PCU 20 and PCU 50.2)

Floppy disk drive (only PCU 20 and PCU 50.2)

PCMCIA Card (only PCU 20)

Network connection

840D/828D SINUMERIK Operate

Operating area "Program manager"

This document was produced for training purposes.

Siemens assumes no responsibility for its contents.

Sinumerik 828d