Siemens Sinumerik 840D Operating Turning page 391

Various
5.1 Selecting the function "Various"
The function "Various" can be selected from the operating mode "JOG",
"MDA" or "AUTO" in the operating area "Program" as follows:
Press the HSK 6 "Various" to switch over to the func-
tion "Various".
A screen similar to the screen shown below opens.
5.2 Vertical softkey bar 1 and 2
Display area Description
By pressing the VSK 1.1 "Blank" an input mask
opens where you can change the settings for the
blank (see section 5.3 "Blank").
By pressing the VSK 1.6 "Subprogram" the input
mask for loading a subprogram to the main program
opens (see section 5.4 "Subprogram").
By pressing the VSK 1.8 "Extend" the vertical soft-
key bar 2 opens.
By pressing the VSK 2.1 "HighSpeed settings" the
input mask for adjusting the settings for the optimal
speed in relation to the machining method opens
(see section 5.5 "HighSpeed settings").
By pressing the VSK 2.8 "Back" you switch back to
the vertical softkey bar 1.
840D/828D SINUMERIK Operate
Section 5
Notes