Siemens Sinumerik 840D Operating Turning page 613

Simple programming example
The following program block "Program header" will
be inserted into the workplan:
3. Program now the contour description for the turning
machining.
For this, press the HSK 1.4 "Cont. turn." in order to
activate the function "Contour turning".
Press the VSK 1 "New contour".
An input window opens where you can enter a suit-
able name for the new contour.
4. Fill out the input mask as follows:
Accept your input by pressing the VSK 8 "Accept".
The operating area for the contour description
opens, with the input window for defining the start-
point of the contour.
840D/828D SINUMERIK Operate
Section 2
Notes