Siemens Sinumerik 840D Operating Turning page 359

Selection and function of the operating area "Diagnostics"
2.1 Selecting the operating area "Diagnostics"
The operating area "Diagnostics" can be selected as follows:
Press the "ALARM"-key on the CNC-Keyboard.
The operating area "Diagnostics" opens
immediately.
- OR -
Press the "MENU SELECT"-key on the CNC-
keyboard.
The following horizontal softkey bar opens on the Sinumerik Operate.
Press the HSK 5 "Diagnostics" to open the operating
area "Diagnostics".
The following softkeys and functions are available in the horizontal soft-
key bar of the operating area "Diagnostics".
2.2 Horizontal softkey bar 1
Display area Description
By pressing the HSK 1 "Alarm list" the "Alarms"-
window opens.
See section 3 "Alarm list".
By pressing the HSK 2 "Messages" the "Messages"
-window opens.
See section 4 "Messages".
By pressing the HSK 3 „Alarm log." a protocol list
with all alarms and messages opened so far are
displayed.
See section 5 "Alarm log".
By pressing the HSK 4 "NC/PLC variab." a window
opens where you can observe and modify PLC
memory locations and NC system variables.
This function is described in the commissioning
manual of the Sinumeik Operate.
By pressing the HSK 1.6 "Remote diag" a window
opens where you can make the settings for remote
diagnostics (RCS).
This function is described in the commissioning
manual of the Sinumerik Operate.
840D/828D SINUMERIK Operate
Section 2
Notes