Section 3
Notes
B641
B641
Complex programming example
3.1 Programming example: Shaft
The following program, with the call up of several "Straight"-cycles and a
"Circle radius"-cycle is to be created.
1.
Create a new ShopTurn program like described in
section 2.1 in this module.
Give the program the following name:
"ST_STRAIGHT_CIRCLE_2.MPF".
The program, with the parameter mask for the pro-
gram header opens by default.
2.
Here, enter the following values into the program
header input mask:
Page 10
840D/828D SINUMERIK Operate