Siemens Sinumerik 840D Operating Turning page 333

Options in the editor
3.1 Horizontal softkey bar:
In this section the general functions of the programming with the
SINUMERIK Operate will be described.
More information is available in the corresponding modules.
By pressing the HSK 2 "Drill." the following cycles for
drilling will be called up:
See module B610 and B611 "Drilling".
By pressing the HSK 3 "Turning" the following cycles
for turning will be called up:
See module B625, B626, B633 and B634 "Turning".
By pressing the HSK 4 "Cont. turn." the following cy-
cles for contour turning will be called up:
840D/828D SINUMERIK Operate
Centering
Drilling and Reaming
Deep hole drilling
Boring
Thread
Positions
Position repetitions
Stock removal
Groove
Undercut
Thread
Cutoff
Contour
Stock removal
Cut residual stock
Grooving
Groove residual
Part
Part residual
Section 3
Notes