Siemens Sinumerik 840D Operating Turning page 603

Complex programming example
Confirm your inputs by pressing the VSK 8 "Accept".
The following programm block is inserted into the
program:
9. Insert the last stock removal cycle into the program.
Press the VSK 1 "Stock removal".
The work area for the technology "Stock removal"
opens.
Press the VSK 4 "Stock removal 2", to open the pa-
rameter mask for the "Stock removal 2" cycle.
10. Insert the following values into the parameter mask:
To insert a tool into the parameter window, press the
VSK 1 "Select tool".
Mark the desired tool (ROUGHING_TOOL_A80) in
the tool list with the orange selection cursor and
press the VSK 1 "To program".
Confirm your inputs by pressing the VSK 8 "Accept".
The following program block is inserted into the pro-
gram:
11. Insert a groove cycle into the program.
Press the VSK 2 "Groove".
The work area for the technology "Groove" opens.
840D/828D SINUMERIK Operate
Section 3
Notes