Siemens Sinumerik 840D Operating Turning page 257

Simultaneous recording
Display area Description (continuation)
By pressing the VSK 4.3 "Zoom -" you zoom out of
the window to reduce the graphical representation
of the workpiece.
Alternatively you can press the minus ("-") key on
the number block of the keyboard.
By pressing the VSK 4.4 "Zoom" a zoom window in
the shape of a right angled frame is placed on the
screen.
With the VSK "Zoom +" and the VSK "Zoom -" you
can increase or decrease the size of the right an-
gled frame and therefore the zoom-factor.
Alternnatively you can use the plus ("+") or minus
("-") key on the keyboard.
The blue cursor keys on the keyboard are used to
adjust the frame on the screen, adjusting the frag-
ment you wish to magnify. After pressing the VSK 8
"OK" the screen will be zoomed in to the extend of
the frame window.
By pressing the VSK 4.5 "Rotate view" the vertical
softkey bar 5 opens (see section 6.5).
By pressing the VSK 4.8 "Back" on the operator
panel you switch back to the vertical softkey bar 1.
6.5 Vertical softkey bar 5 (from VSK 4.5 "Rotate view")
Display area Description
By pressing the VSK 5.1 the workpiece will be
turned right around its own vertical center line.
By pressing the VSK 5.2 the workpiece will be
turned left around its own vertical center line.
By pressing the VSK 5.3 the workpiece will be
turned upwards around its own horizontal center
line.
By pressing the VSK 5.4 the workpiece will be
turned downwards around its own horizontal center
line.
By pressing the VSK 5.5 the workpiece will be
turned left (counterclockwise) around the center of
the screen.
By pressing the VSK 5.6 the workpiece will be
turned right (clockwise) around the center of the
screen.
By pressing the VSK 5.8 „Back" on the operator
panel you switch back to the vertical softkey bar 4.
840D/828D SINUMERIK Operate
Section 6
Notes