Siemens Sinumerik 840D Operating Turning page 489

Complex programming example
10. Insert the following values into the parameter mask:
Confirm your inputs by pressing the VSK 8 "OK".
The following line is inserted into the program:
__MVAR=2 _MA=1 _SETVAL=100 _FA=10
_TSA=10 _KNUM=0 _PRNUM=1 _TDIF=1 _TUL=1
_TLL=0 _VMS=0 _NMSP=1 _SZA=10 _SZO=120
_CHBIT[4]=0 _TMV=0.333333333333333 _K=1
_EVNUM=0
CYCLE994
11. At last, program the end of the program with the fol-
lowing G code command:
N160 M30
12. Simulate now the measurement of the workpiece.
Switch back to the horizontal softkey bar 1 by press-
ing the „Extend"-key on the operator panel.
Press the HSK 1.7 „Simulation" to start the simula-
tion of the program.
The control calculates the simulation parameters
and opens the simulation in the simulation window in
"Top view".
First, the face side of the workpiece is measured,
then successively the barrel.
840D/828D SINUMERIK Operate
Section 3
Notes