Siemens Sinumerik 840D Operating Turning page 576

Section 3
Notes
B610
B610
Complex programming example
To insert a tool into the parameter window, press the
VSK 1 "Select tool".
Mark the desired tool (DRILL_D8.5) in the tool list
with the orange selection cursor and press the VSK
1 "To program".
The following program block "Drilling" will be inserted
into the work plan:
The program chain will be extended.
Note the bilateral opened bracket on the right side of
the programming symbol.
6. Program now the tapping cycle.
Press the VSK 5 "Tapping".
The parameter window for the "Tapping"-cycle
opens.
7. Enter the following values into the parameter win-
dow:
To insert a tool into the parameter window, press the
VSK 1 "Select tool".
Mark the desired tool (TAP_M10) in the tool list with
the orange selection cursor and press the VSK 1 "To
program".
The following program block "Tapping" will be in-
serted into the work plan:
The program chain will be extended.
Note the bilateral opened bracket on the right side of
the programming symbol
.
8. Program now the position pattern for the drilling, in
order to close the program block chain.
Press the VSK 7 „Positions".
The positions window opens.
To set the positions for the drillings press the VSK 5
"Position circle".
The "Position circle" window opens.
Page 10 840D/828D SINUMERIK Operate