Siemens Sinumerik 840D Operating Turning page 301

Hide thumbs Also See for Sinumerik 840D:

Magazine management

Enter the location number you require and press the

Press the VSK 4 "Spindle" to load a tool into the

spindle and press the VSK 8 "OK".

The tool is moved to the specified magazine location

or the spindle.

Several magazines

If you have set up several magazines, then the "...move from magazine...

location... to..." window appears after pressing the VSK 5 "Relocate" .

Select the desired magazine and location, and confirm your selection with

the VSK 8 "OK" to load the tool.

5.6 Positioning a magazine

You can position magazine locations directly on the loading point.

Press the "MENU SELECT"-key on the operator

panel, then the HSK 2 "Parameter" to open the oper-

ating area "Parameter". Alternatively press the

"OFFSET"-key on the keyboard.

Press the HSK "Magazine".

The magazine window opens.

Place the cursor on the magazine location that you

want to position onto the load point.

Press the VSK 6 "Position magazine".

Select a loading point in the input mask.

The magazine location is positioned on the loading

Several load points

If you have configured several loading points for a magazine, then the

"Load Point Selection" window appears after pressing the VSK 6 "Position

Select the desired loading point in this window and confirm your selection

with the VSK 8 "OK" to position the magazine location at the loading point.

840D/828D SINUMERIK Operate

Sinumerik 828d