Siemens Sinumerik 840D Operating Turning page 590

Section 3
Notes
B617
B617
Complex programming example
5. Now, program a single position for the machining of
the rectangular pocket.
Press the HSK 1.2 "Drill." to open the function
"Drilling".
Press the VSK 7 "Positions".
The work area for the the technology "Positions"
opens.
Press the VSK 3 "Positions" to open the input mask
for the cycle "Positions".
The following parameter window opens:
6. Insert the following values into the parameter mask:
7. Confirm your inputs by pressing the VSK 8 "Accept".
The following program block "Positions" is inserted
into the work plan window:
The program chain closes (note the downward
closed bracket on the right side of the programming
symbol).
8. At the end, program the end of the program and
simulate the machining.
Place the orange selection cursor on the program
block "End of program" and switch to the parameter
mask for the program end by pressing the blue
"cursor-to-the-right" key on the keyboard.
The settings window for the program end opens,
where you can define to repeat the workpiece.
Accept the default value and press the VSK 8
"Accept".
The following program block "End of program" is up-
dated:
Page 10 840D/828D SINUMERIK Operate