Siemens Sinumerik 840D Operating Turning page 393

Hide thumbs Also See for Sinumerik 840D:

Meaning (continuation)

Outside diameter (only with pipe or cylinder)

Inside diameter (absolute or incremental)

Number of edges (only with N corner)

Width across flats (only with N corner)

Width of blank (only with Block centered)

Length of blank (only with Block centered))

5.3.3 Changing the graphical view on the blank

The graphic view on the blank is adjustable under the function "Various" ,

as well as under the technologies Drilling", "Turning" and "Milling", by

pressing the VSK 2 "Graphic view".

Help pictures and animations are only displayed if the VSK 2 "Graphic

view" is deselected.

You can change the graphic view on the blank as follows:

In the operating area "Program" press the HSK 1.6

Press the VSK 1.1 "Blank" to open the input mask

for the blank settings.

Activate or deactivate the VSK 2 "Graphic view" to

switch between a:

840D/828D SINUMERIK Operate

3D view/side view

Sinumerik 828d