Siemens Sinumerik 840D Operating Turning page 661

Complex programming example
Description:
Another program with an additional measuring movement on the face side
of a cylinder barrel is to be programmed in ShopTurn.
Aim:
The program header, two measuring cycles and the program end are to be
programmed.
Afterwards the program is to be simulated.
For this, the data below are to be used:
Tool data: 3d probe (3D_PROBE)
2.2 Programming example : Measuring the face side and the barrel
of a cylinder
The following program with two measuring cycles is to be programmed:
1. Create a new ShopTurn program like described in
the previous section 2.1.
Give the program a name, for example
"ST_MEASURE_TURNING_2.MPF".
The input window for the program header opens.
840D/828D SINUMERIK Operate
Section 3
Notes