Siemens Sinumerik 840D Operating Turning page 612

Section 2
Notes
B633
B633
Simple programming example
2.2 Example: Bevel
The following sequential program, with the call up of a contour, chained
with a stock removal cycle, is to be programmed.
1. Create a new ShopTurn program like described in
the previous section 2.1.
Give the program a name, for example
"ST_CONTOURTURNING_1.MPF".
The input window for the program header opens.
2. Enter the following values for the program header
and accept your inputs by pressing the VSK 8
"Accept".
Page 4 840D/828D SINUMERIK Operate