Siemens Sinumerik 840D Operating Turning page 597

Simple programming example
Confirm your inputs by pressing the VSK 8 "Accept".
The following program block "Program header" will
be inserted into the work plan.
3. Program a stock removal cycle.
Press the HSK 1.3 "Turning".
Press the VSK 1 "Stock removal".
The work area for the technology "Stock removal"
opens.
Press the VSK 3 "Stock removal 1", to open the pa-
rameter mask for the "Stock removal 1" cycle.
4. Enter the following values into the parameter mask:
To insert a tool into the parameter mask, press the
VSK 1 "Select tool", mark the desired tool
(ROUGHING_TOOL_A80) in the tool list with the
orange selection cursor and press the VSK 1 "To
program"
The following program block "Stock removal" will be
inserted into the program.
5. Program the end of the program and simulate the
machining.
Place the orange selection cursor on the program
block "End of program" and extend the program
block by pressing the blue "cursor-to-the-right"-key
on the keyboard.
The settings window for the program end opens,
where you can define to repeat the workpiece.
Accept the default value by pressing the VSK 8
"Accept". The program end is updated.
840D/828D SINUMERIK Operate
Section 2
Notes