Siemens Sinumerik 840D Operating Turning page 628

Section 3
Notes
B633
B633
Complex programming example
40. Insert a stock removal cycle into the program.
Press the VSK 1.2 "Stock removal" to open the pa-
rameter mask for the "Stock removal" cycle.
41. Fill out the parameter mask as follows:
In order to insert a tool into the parameter mask,
press the VSK 1 "Select tool", mark the appropriate
tool (ROUGHING_TOOL_A80) with the orange
selection cursor and press the VSK 1 "To program".
Accept your selection by pressing the VSK 8
"Accept".
The program block "Stock removal" will be inserted
into the work plan:
The program chain is extended.
42. Insert a "Residual cutting" cycle into the program.
Press the VSK 3 "Cut resid stock" to open the pa-
rameter mask for the "Cut residual material" cycle.
The parameter mask for the "Cut residual material"
opens.
Page 20 840D/828D SINUMERIK Operate