Section 3
Creating ShopTurn programs
Notes
3.2 Setting the program header
After entering a name for the program and pressing the VSK 8 "OK" the
program header window opens automatically.
Here you can enter parameters for the measuring units, the work offset,
the spindle, the blank, the retraction mode, the tool change point, the
safety distance, the speed limits and the machining sense (alike picture
below).
Enter the appropriate parameter values and confirm with pressing the VSK
8 "Accept" or abort with pressing the VSK 7 "Cancel", to switch back to the
work plan window.
The control switches to the work plan view in the program editor.
Program header and program header are programmed automatically.
B601
B601
Page 8
840D/828D SINUMERIK Operate