Siemens Sinumerik 840D Operating Turning page 643

Complex programming example
3. Confirm your inputs by pressing the VSK 8 „Accept".
The following program block is inserted into the
workplan:
4. Inset now a tool (FINISHING_TOOL_55) into the
program.
In order to do this, switch to the horizontal softkey
bar 2, by pressing the "Extend"-key on the operator
panel.
The horizontal softkey bar 2 opens.
Press the HSK 2.2 "Strght Circle" to select the func-
tion "Straight Circle".
The operating area of the function "Straight Circle"
opens.
Now press the VSK 1 "Tool" to open the input mask
for the tool (see picture below).
To insert a tool into the parameter mask, press the
VSK 1 "Select tool".
The tool list window opens.
Here, place the orange selection cursor on the tool
"FINISHING_TOOL_55", by using the blue cursor
keys on the keyboard and press the VSK 1 "To pro-
gramm".
The selected tool is inserted into the tool input mask
like displayed below
5. Fill out the rest of the input mask, as follows:
Confirm your inputs by pressing the VSK 8 "Accept".
The following program block is inserted into the work
plan:
840D/828D SINUMERIK Operate
Section 3
Notes