Siemens Sinumerik 840D Operating Turning page 637

Simple programming example
The program block "Program header" is inserted into
the work plan:
4. Insert now a tool (FINISHING_TOOL_35) into the
program.
Switch to the horizontal softkey bar 2, by pressing
the "Extend"-key on the operator panel.
The horizontal softkey bar 2 opens.
Press the HSK 2.2 "Strght Circle" to select the func-
tion "Straight Circle".
The operating area of the function "Straight Circle"
opens.
Press the VSK 1 to open the input mask for the tool
(see picture below).
To insert a tool into the tool window, press the
VSK 1 "Select tool". In the opening tool list window
select the tool "FINISHING_TOOL_35" and press
the VSK 1 "To program".
The tool is inserted into the input mask.
Fill out the rest of the input mask like displayed
above.
5. Confirm your inputs by pressing the VSK 8 "Accept".
The following program block is inserted into the work
plan:
6. Insert now the first of several "Straight"-cycles into
the program.
Press the VSK 2 "Straight" to open the input window
for the function "Straight".
The input window for the function "Straight" opens.
840D/828D SINUMERIK Operate
Section 2
Notes