Siemens Sinumerik 840D Operating Turning page 433

Hide thumbs Also See for Sinumerik 840D:

1 Brief description

Objective of the module:

Working through this module you become familiar with the technology „Contour turning" by program-

ming two G code programs with the programGUIDE in ShopTurn.

Description of the module:

This module explains the programming of a contour turning machining with the programGUIDE in

ShopTurn, as well as well as the programming of a more complex workpiece by means of contour

descriptions, stock removal- and residual cutting cycles.

840D/828D SINUMERIK Operate

Contour turning

This document was produced for training purposes.

Siemens assumes no responsibility for its contents.

Sinumerik 828d