Siemens Sinumerik 840D Operating Turning page 577

Complex programming example
9. Enter the following values into the parameter mask:
Confirm your inputs by pressing the VSK 8 "Accept".
The following program block "Position circle" will be
inserted into the work plan:
The program chain will be closed.
Note the upward opened bracket on the right side of
the programming symbol.
10. Program now the program end and simulate the ma-
chining.
Place the orange selection cursor on the "End of
Program" program block.
Extend the program block by pressing the blue
"cursor-to-the-right"-key on the keyboard.
The input mask for the "End of program" opens.
11. The settings window for the program end opens,
where you can define to repeat the workpiece.
Accept the default value by pressing the VSK 8
"Accept".
The program block "End of program" will be updated.
Press the HSK 1.7 "Simulation" to start the simula-
tion of the program.
The control calculates the simulation parameters
and opens the simulation in the simulation window in
"Side view" by default.
840D/828D SINUMERIK Operate
Section 3
Notes