Siemens Sinumerik 840D Operating Turning page 481

Simple programming example
Description:
A simple measuring movement on the face side of a cylindrical workpiece
is to be programmed with the programGUIDE in ShopTurn.
Aim:
A new G code program is to be created and opened in the editor window.
The G code lines and the measuring cycle are to be programmed and the
program is to be simulated
For this, the data shown below is to be used:
Tool data: 3D-probe (3D_PROBE)
2.1 Creating a new programGUIDE program
A new programGUIDE program can be created from within all operating
modes as follows:
1. Press the "Program Manager"-key on the keyboard.
The program manager is opened directly.
- OR -
1. Press the "MENU SELECT"-key on the operator
panel.
Press the yellow HSK 4 "Program Manager".
The program manager opens.
2. Select a drive, where you want to create the pro-
gram ("NC", "Local drive", "USB").
3. Press the VSK 2 "New".
The vertical softkey bar for creating new programs
opens.
4. Press the VSK 4 "programGUIDE G code" to open
the input mask for creating a new G code program.
Enter a name for the program in the "Name" field,
e.g. "DIN_MEASURING_1.MPF" and accept with
pressing the VSK 8 "OK".
The program is loaded to the editor.
840D/828D SINUMERIK Operate
Section 2
Notes