Siemens Sinumerik 840D Operating Turning page 609

Hide thumbs Also See for Sinumerik 840D:

1 Brief description

Objective of the module:

Working through this module you become familiar with the technology "Contour turning" by program-

ming two chained sequential ShopTurn programs.

Description of the module:

This module explains the programming of a simple ShopTurn program (bevel), by using contour cycle

chained togther with a stock removal cycle, as well as well as the programming of a more complex

workpiece by means of chained contours, stock removal- and residual cutting cycles.

840D/828D SINUMERIK Operate

Contour turning

This document was produced for training purposes.

Siemens assumes no responsibility for its contents.

Sinumerik 828d