Siemens Sinumerik 840D Operating Turning page 611

Hide thumbs Also See for Sinumerik 840D:

Simple programming example

Description:

A simple contour turning program, using a contour and stock removal cycle

is to be programmed as a chained sequential program with ShopTurn func-

A new sequential program is to be created and opened in the editor.

A contour description and a stock removal cycle are to be programmed

and the program is to be simulated.

For this, the data shown below are to be used:

ROUGHING_TOOL_A80

Technology data:

F 0,4 mm/U, V 200 m/min

Starting-up technol-

As a start position for the machining, the following

position will be programmed:

This position is approached in rapid traverse.

2.1 Creating a new sequential ShopTurn program

A new ShopTurn program can be created in all operating modes, as fol-

Press the "Program Manager"-key on the keyboard.

The program manager will be opened directly.

Press the "MENU SELECT"-key on the operator

Press the yellow HSK 4 "Program Manager".

The program manager opens.

Select a drive, where you want to create the pro-

gram ("NC", "Local drive", "USB").

Press the VSK 2 "New".

The vertical softkey bar for creating new programs

Press the VSK 3 "ShopTurn" to open the input mask

for creating a new ShopTurn sequential program.

Enter a name for the program in the "Name" field

and accept with pressing the VSK 8 "OK".

The program is loaded to the editor and the parame-

ter window for the program header is opened by de-

840D/828D SINUMERIK Operate

Sinumerik 828d