Siemens Sinumerik 840D Operating Turning page 682

Section 3
Notes
B657
B657
Complex programming example
Enter the following position values and press the
VSK 5 "Rapid traverse" to change the selection
feedrate to rapid traverse rate.
Acknowledge with VSK 8 "Accept".
The following program block is added to the work
schedule.
8. Now programme the measuring cycle "Workpiece
measure/Hole CYCLE977".
For this press the HSK 2.6 "Measurem. milling" on
the extended horizontal softkey-strip.
The operating range "Measurement milling" with the
extended measuring functions opens.
Press the VSK 4 "Workpiece measure".
The vertical softkey-strip with functions for the meas-
uring of workpieces opens.
Press the VSK 2 "Hole Shaft".
The vertical softkey-strip with functions for the meas-
uring of Holes or Shafts opens.
The key "Hole" is pre-set and is therefore shown in
blue.
The input window for the cycle 977 "Measurement
milling977" opens (see the illustration on the next
page).
Page 14 840D/828D SINUMERIK Operate