Siemens Sinumerik 840D Operating Turning page 618

Hide thumbs Also See for Sinumerik 840D:

Complex programming example

Description:

A more complex ShopTurn sequential program (spigot) is to be pro-

grammed, by using different turning cycles (contour, stock removal, resid-

ual cutting).

The workpiece shown below is to be programmed.

Then the program is to be simulated.

The following tool- and technology data are to be used:

ROUGHING_TOOL_A80

(F 0,3 mm/U, V 260 m/min)

Technology data:

BUTTON_TOOL_8

(F 0,25 mm/U, V 240 m/min)

FINISHING_TOOL_35

(F 0,12 mm/U, 280 m/min)

Starting-up technol-

The following position is programmed as the

contours starting point:

This point will be approached in the cycle automati-

cally with rapid traverse.

840D/828D SINUMERIK Operate

Sinumerik 828d