Siemens Sinumerik 840D Operating Turning page 272

Section 2
Notes
B523
B523
Operating area "Parameter"
2.1 Selecting the operating area "Parameter"
All screens under the operating area "Parameter" display the same tool
and in the same order.
The position of the cursor on a particular tool in the current screen is car-
ried over to the same tool in a new screen.
Switching between lists is a specific change from one topic to the next.
Tool list (HSK 1)
All parameters and functions required to create and set up tools are dis-
played.
Tool wear (HSK 2)
All parameters and functions that are required during operation, e.g.
wear and monitoring functions, are listed here.
Magazine (HSK 4)
Magazine and magazine location-related parameters and functions for
the tools and magazine locations are listed here.
The operating area "Parameter" can be opened from every operating
modes ("JOG", "MDA", "AUTO").
Press the "OFFSET"-key on the keyboard.
The operating area "Parameter" respectively the
"Tool list" opens directly.
- OR -
Press the "MENU SELECT"-key on the operator
panel.
The yellow horizontal and vertical softkey bar opens.
Then switch to the operating area "Parameter" by
pressing the HSK 2 "Parameter" on the operator
panel.
The operating area "Parameter" opens, including the
"Tool list", "Tool wear", "Magazine", "Work offset",
"User variables" and the "Setting data".
These functions are made available in the following
described horizontal softkey bar.
2.2 Horizontal softkey bar (HSK)
Display area Description
By pressing the HSK 1 "Tool list" the tool list win-
dow opens.
See section 3 "Tool list".
By pressing the HSK 2 "Tool wear" the tool wear list
opens.
See section 4 "Tool wear".
Page 8 840D/828D SINUMERIK Operate