Siemens Sinumerik 840D Operating Turning page 649

Hide thumbs Also See for Sinumerik 840D:

Complex programming example

Insert the following values into the parameter mask:

Confirm your inputs by pressing the VSK 8 "Accept".

The following program block is inserted into the pro-

Now insert the last "Straight"-cycle into the program.

Press the VSK 2 "Straight", to open the input mask

for the function "Straight".

Insert the following values into the parameter mask:

Confirm your inputs by pressing the VSK 8 "Accept".

The following program block is inserted into the pro-

Program now the end of the program and simulate

the machining afterwards.

For this, place the orange selection cursor on the

program block "End of program", using the blue cur-

sor keys on the keyboard.

Press the "cursor-to-the-right"-key in order to switch

to the input mask for the "End of program".

Here you can adjust whether you want to repeat the

program run or not.

Accept the default value "No" by pressing the VSK 8

840D/828D SINUMERIK Operate

Sinumerik 828d